Skip to main content

Direct, repeater, digipeater or mesh?

Beginner level · About 10 minutes

You know how one radio can reach another. What happens when they are too far apart? There are several ways to extend communication, but not every system that relays a message is a mesh network.

Four simplified layouts: direct radio, voice repeater, digipeater and mesh.

1. Direct: radio A talks to radio B​

In direct communication, a transmitter sends a signal to a receiver without another station intentionally relaying it. Many walkie-talkies use this approach.

Why choose it? Simple and independent of other stations. Limitation: both ends need a workable radio path.

2. A voice repeater: an intermediate station retransmits​

A repeater is typically installed at a favorable location, such as a tower or hill. A common voice repeater receives on one frequency and retransmits on another, allowing stations that cannot directly hear each other to communicate through it.

Why choose it? Greater coverage for local voice communications. Limitation: the repeater must be available, powered and configured correctly. Repeaters must follow the relevant service rules.

3. A digipeater: a digital packet gets relayed​

A digipeater receives digital packets and retransmits selected packets according to its protocol and settings. APRS commonly uses digipeaters to extend the reach of location reports and messages.

Why choose it? Useful for sharing short reports over a wider area. Limitation: the shared radio channel still has finite capacity; sending excessively frequent packets can make things worse for everyone.

4. A mesh network: multiple possible paths​

In a mesh arrangement, participating devices may help move information through a network of nodes. Depending on the protocol, the software may select or use multiple possible paths or relays. Some systems depend on specific router or repeater roles rather than every device acting identically.

Why choose it? Possible alternative paths and flexibility in certain layouts. Limitation: a mesh doesn't create range from nothing. It still needs useful radio links, compatible protocols and sufficient capacity.

5. Where does the Internet fit?​

Sometimes a station or gateway forwards information to an Internet service. For example, an APRS IGate can exchange data between the radio-side APRS network and APRS-IS, an Internet-based network.

That gateway can be helpful, but the local radio exchange may still work when the Internet does not. Whether a particular service depends on a gateway must be checked system by system.

ArrangementIntermediate station needed?Internet always needed?Typical example
DirectNoNoHandheld-to-handheld voice
RepeaterYes, for the repeated pathNoAmateur or GMRS voice repeater
DigipeaterYes, for the relayed packetNoAPRS packet path
MeshSometimes, for multi-hop reachNo, for local RF pathsLoRa messaging deployments
Internet gatewayFor crossing into online servicesYes, for its online functionAPRS IGate or MQTT bridge

Three common misconceptions​

  1. “Every node is a repeater.” Not always. Device roles and routing methods vary.
  2. “More hops always mean better range.” More transmissions also consume airtime, and a weak or congested network may perform worse.
  3. “APRS is just another mesh network.” No. Conventional APRS broadcast-and-digipeater operation is different from a general mesh routing protocol.

Try thinking through a real situation​

You want to send short text messages between two camps separated by a wooded ridge. What would you investigate?

  • Whether a direct radio path works from each location.
  • Whether a relay station could be placed somewhere with better visibility.
  • Whether the devices and protocols are compatible.
  • What power, antenna, privacy and radio-service limitations apply.

There is no one answer for every terrain or project. That's why we compare possibilities instead of declaring a “correct” network.

Further reading​

Next: Lesson 4 — What equipment does a radio station need?


Questions or a better example? Discuss it on our forum. You can disagree with a recommendation—tell us why.