Skip to main content

Your first radio experiment: explore without transmitting

Beginner level · 10–20 minutes · Receive-only activity

You can start learning RF without buying a mesh node, programming firmware, creating an account or transmitting a single signal.

The experiment​

Use an ordinary FM broadcast receiver—a portable radio, vehicle radio or a receiver you already own—to observe how changing frequencies affects what you hear.

What you'll need: an FM receiver that can tune broadcast stations, a way to note observations, and a safe place to listen. That's it.

Step by step​

  1. Switch on the receiver and select the FM broadcast band.
  2. Find one station you can hear clearly. Write down its displayed frequency, such as 100.1 MHz (an example, not a specific station).
  3. Tune slowly away from that frequency and notice how sound changes. Find a second station.
  4. Compare locations if practical: try closer to a window, in another room, or outside where safe. Note whether reception changes.
  5. Write down a question: Why was one station stronger? Why was another hard to hear? Did the radio seem to select only one part of the band?
What just happened?

Your radio was receiving, not transmitting. By tuning, you told the receiver what part of the radio-frequency spectrum to pay attention to. Moving the receiver or antenna changed its environment, which can affect reception.

What your observations do—and don't—prove​

If one position sounds clearer, that's evidence that reception at that position and time was better. It does not establish that the transmitter increased power, that every location is the same, or that a particular radio has guaranteed range.

A simple experiment becomes useful when you repeat it, change one variable at a time and record the results.

Troubleshooting​

ProblemThings to check
No station is audibleIs the receiver on FM broadcast, not AM or another mode? Is the volume on?
Reception is weakTry moving away from electrical devices or near a window, if safe. Check the antenna.
Tuning shows only station names, not MHzLook for a frequency-display option in the receiver's manual; it is not required for the basic observation.
You don't own an FM radioSkip the experiment for now; Lessons 1–5 are still useful and need no hardware.

Optional next experiment​

If you already own a compliant receive-only scanner or weather radio, see whether it receives a local NOAA Weather Radio broadcast. Not every location has good reception. You do not need an amateur license merely to listen to transmissions that are legal to receive.

Share what you learned​

Post your observations in the community forum. Include your receiver type, where you tried it (avoid posting your precise private address), what changed and what question you're trying to answer.

That is what experimentation looks like: observe → question → test → learn → share.

Where to go next​