Skip to main content

Plain-English radio glossary

If you see a word you don't recognize, you're not behind. Technical language should be explained, not used as a barrier. Some guides include tappable definitions; this page is the place to go deeper.

79 of 79 terms shown

Antenna
The part of a radio system that sends radio energy into space or picks it up from space.
Antenna efficiency
The fraction of power accepted by an antenna that is actually radiated rather than dissipated as heat or other losses. Low SWR does not prove high efficiency.
Antenna gain (dBi)
Antenna response in a particular direction compared with an ideal isotropic radiator. It describes directional concentration, not newly created transmitter power.
Antenna matching
Adjusting an antenna system's impedance so the transmitter or receiver sees an appropriate load and reflections are reduced; a good match does not prove good radiation efficiency.
APRS
Automatic Packet Reporting System: a system for sharing short reports such as positions, status and weather, often over amateur packet radio.
Azimuth pattern
An antenna's relative response around the horizon at a specified elevation, usually plotted by compass direction.
Bandwidth
How much of the radio-frequency spectrum a signal or channel occupies, or a receiver lets through. Wider is not automatically better.
Bit / Byte
A bit is one binary digit (0 or 1). A byte usually groups eight bits.
Coaxial cable (coax)
A shielded transmission line with a center conductor used to carry radio-frequency energy between a radio and an antenna.
Coding rate (CR)
In LoRa, a setting related to extra information sent for error correction. More redundancy can help with some errors, but costs airtime.
Collinear antenna
An antenna using multiple aligned radiating sections to shape its pattern, often a vertical designed for more gain near selected elevation angles.
Counterpoise
A conductive return structure, such as radials or an appropriate vehicle body, that forms part of some antenna systems.
dBd
Antenna gain compared with a reference half-wave dipole under equivalent conditions. In free space, 0 dBd is about 2.15 dBi.
dBm
A power level expressed in decibels relative to one milliwatt. Negative values are common for received radio signals.
Decibel (dB)
A way to compare ratios, often used for signal levels or gains.
Device metrics
Measurements about a device itself, such as battery level, voltage and channel or airtime usage.
Digipeater
A digital relay that receives and retransmits selected data packets, common in APRS.
Dipole antenna
An antenna with two conductive arms fed between them. A half-wave dipole is a common reference with a broadside radiation pattern.
Duplexer
A filter assembly that allows a repeater to share one antenna between a transmitter and receiver operating on different frequencies while helping keep transmitted energy out of the receiver.
EIRP / ERP
Effective isotropic radiated power / effective radiated power: transmitter power adjusted for feedline losses and antenna gain, referenced respectively to an isotropic radiator or dipole.
Elevation pattern
An antenna's relative response as the angle above or below the horizon changes; crucial for reaching hillsides, nearby stations and distant horizons.
Environment telemetry
Temperature, humidity, pressure or other supported environmental readings sent by a device using suitable sensors and firmware.
Feedline
Cable used to carry radio-frequency energy between a radio and an antenna.
Flood forwarding
A routing method in which eligible repeaters rebroadcast a packet so it can spread through a network, consuming shared radio airtime.
Frequency
How many times an oscillating pattern repeats each second. Measured in hertz (Hz).
Fresnel zone
A three-dimensional region around a radio path where objects can alter how waves combine at the receiver, even if the direct line of sight appears clear.
Gateway / IGate
A system that connects two kinds of communication networks; in APRS, an IGate links radio-side packets with the Internet APRS-IS system.
GMRS
General Mobile Radio Service, a U.S. personal radio service with its own license, frequency and equipment rules.
GPS / GNSS
Satellite navigation systems used by supported radios and phones to determine geographic position. Satellite position reception itself does not require cellular Internet service.
Ground plane
A conductive surface or set of radials that serves as part of some antennas' RF return system and helps shape their radiation pattern. It is not the same thing as a lightning safety ground.
Grounding and bonding
Connecting appropriate conductive parts and electrical protection systems according to code and site design. RF counterpoises, electrical safety grounding and lightning protection serve different purposes.
Hop limit
A limit on how many further radio relays a packet is permitted to make. It helps control how far retransmissions spread and how much radio airtime is used.
I²C
Inter-Integrated Circuit: a short-distance electrical communication bus often used between a microcontroller and sensors over SDA (data) and SCL (clock) connections.
IATA-style observer code
A three-letter geographic label some observer and MQTT reporting systems use to group received packet reports, such as GDW. It is not itself a MeshCore RF forwarding scope.
Impedance
Frequency-dependent opposition to alternating current, including resistance and reactance; 50 ohms is a common nominal radio-system value.
Insertion loss
Signal power lost while passing through a device or cable, commonly expressed in decibels.
Isotropic radiator
An imaginary, ideal antenna that radiates equally in every direction in three dimensions. It is the reference for gain measured in dBi; no real physical antenna is perfectly isotropic.
Link budget
An accounting of gains and losses along the radio path, including transmitted power, antennas, feedlines and propagation, used to estimate the signal available at a receiver.
LoRa
A radio modulation technology designed for low-data-rate links, often at low power and sometimes over long distances. Not itself a complete messaging network.
Mesh network
A network where devices can participate in moving data through multiple possible paths, depending on the protocol and device roles.
MeshCore region scope
A named region selected for a MeshCore flooded packet. Repeaters configured to recognize and allow the same scope may forward it; this is separate from an observer's location code.
Modulation
The process of changing a transmitted signal to represent information.
MQTT
A lightweight publish/subscribe messaging protocol, typically used over IP networks. Some radio projects use it to exchange information through Internet-connected servers.
MQTT broker
A server that receives messages published on topics and distributes them to subscribers over an IP network, often the Internet. It is not itself a LoRa radio repeater.
MQTT downlink
Receiving selected packets from an MQTT broker at a gateway and offering or transmitting them to its local radio mesh, subject to settings and policy.
MQTT gateway
A device or service that bridges packets between a local radio mesh and an MQTT broker over an IP connection. If Internet-connected, its remote reach depends on that connection.
MQTT uplink
Forwarding selected Meshtastic packets received over radio from a gateway to an MQTT broker using an IP connection.
Node
A participating device or station in a communication network. What a node does depends on the system.
Noise floor
The combined background noise level a receiver sees in its selected bandwidth. A higher noise floor makes weak signals harder to distinguish.
Observer
A device or station that listens for radio packets and may report observations to mapping or monitoring services. Its reporting area does not itself control repeater forwarding.
Omnidirectional antenna
An antenna designed to provide approximately even coverage around the horizon in azimuth; it does not radiate equally in every three-dimensional direction.
Packet
A formatted unit of digital information transmitted through a communication system.
Polarization
The orientation or rotation of the electric field of a radio wave; vertical, horizontal and circular polarization are examples.
Position precision
A setting that reduces how accurately shared coordinates describe a node's real location. Lower precision helps privacy but doesn't guarantee anonymity.
Pre-shared key (PSK)
A secret key shared by intended channel members so they can decrypt messages on that channel. A publicly known default key is not private.
Protocol
The agreed rules that systems use to format, send and understand information.
Quarter-wave vertical
A vertical antenna whose radiating section is approximately a quarter wavelength electrically, commonly used with a ground plane or other counterpoise.
Radiation efficiency
The fraction of power accepted by an antenna that is radiated rather than converted to heat or otherwise lost in its materials.
Radiation pattern
A description or diagram of how strongly an antenna transmits or receives in different directions.
Receiver (RX)
A device or circuit that picks up and processes incoming signals.
Receiver desensitization
A loss of receiver sensitivity caused by strong nearby signals or interference that make weak desired signals harder to detect.
Repeater
A station that retransmits received signals to extend coverage. Voice repeaters and packet digipeaters aren't identical.
Resonance
A condition where an antenna feedpoint's reactive impedance is approximately zero at a particular frequency; it is not necessarily a 50-ohm match.
Return loss
A decibel measure related to reflected signal power at an RF connection. Higher positive return-loss values generally indicate a better match.
RF
Radio frequency: the part of the electromagnetic spectrum used for radio systems.
RSSI
Received Signal Strength Indicator: an estimate of received signal strength; exact interpretation depends on the device.
S11
A network-analyzer measurement of the signal reflected at an RF connection, usually expressed as a complex reflection coefficient or converted to return loss or VSWR. It does not directly measure antenna efficiency.
SNR
Signal-to-Noise Ratio: a measure of wanted signal compared with noise.
Spreading factor (SF)
A LoRa setting affecting symbol duration, speed, receiver sensitivity and airtime. Higher isn't automatically better for every network.
SWR / VSWR
Standing wave ratio / voltage standing wave ratio: the ratio caused by RF reflections along a transmission line. A low value indicates a good match but not necessarily good radiation.
Telemetry
Measurements sent from a remote location, such as temperature or battery voltage.
TLS
Transport Layer Security: encryption and authentication for an Internet/IP connection such as a client-to-MQTT-broker link. It does not prevent an authorized broker from processing data it receives.
Transceiver
A radio that can both transmit and receive.
Transmitter (TX)
A device or circuit that generates a signal to send.
UHF / VHF / HF
Names for different broad ranges of radio frequencies. Each supports different uses and propagation behavior.
Unscoped packet
A MeshCore flood packet sent with no region scope. Repeaters can forward it by default or apply separate limits or filtering rules.
Watt (W)
A unit of power. One watt equals 1,000 milliwatts (mW). Transmitter output in watts can also be expressed in dBm; 1 W is 30 dBm.
Wavelength
The distance a radio wave travels during one complete cycle. In free space, it is approximately 300 divided by frequency in MHz, measured in meters.
Yagi antenna
A directional antenna using a driven element and other nearby elements to concentrate response toward selected directions.

Suggest a better definition​

If a definition is confusing or you find an unexplained term, please tell us on the forum. We want to make the wording clearer, not make readers memorize terminology to participate.